Need to change my remote codes

How to program your keyless entry pad or remote.
THERE ARE 2 KINDS OF MOTORS
THE FIRST TYPE IS THE DIP SWITCH TYPE…
If you have this one the remote should be an LM 61 and your K.E.P should be hardwired

All you have to do is match the dip switches on the remote to the one on the motor

The K.E.P should thave a switch that says program move the switch to that spot and then the red light on the K.E.P will blink put your four # in and then move the switch to the run spot and it should work !

THE SECOND TYPE OF MOTOR IS A SMART BUTTON

If you have a GRAY or YELLOW BUTTON on your motor your remote is a LM 61 and your K.E.P is LM 66

If you have a GREEN BUTTON on your motor your remote is a LM 81 BUT LM 61 will work on it and your K.E.P is LM 66

If you have a RED BUTTON on your motor your remote SHOULD be SECURITY + BUT ON some you will find your remotes are LM 81 and your K.E.P is LM 66 if that is so your RED BUTTON IS NOW GREEN and SECURITY + REMOTE AND K.E.P will not work anyways your remote is LM 973 and your K.E.P is 976

If you have a PURPLE BUTTON on your motor your remote is a LM 373 and your K.E.P is an LM 376

Now push the smart button and LET GO then push the remote and then push the remote again and the door sould move your done

Now push the smart button and LET GO you have 30 seconds to run to the K.E.P push your 4 # in and press enter HARD then press enter agian and the door will move PRESS HARD ok

I NEED TO CHANGE MY CODE NOW !

ok If you have the dip switch one then just chance the dipswitchs on the remote and motor and your done to change the K.E.P just pick 4 new # and your done ^ LOOK ABOVE ^

If you have the SMART BUTTON just hold the smart button until the little light goes out switch is about 30 second and the reprogram the remotes and K.E.P ^ LOOK ABOVE ^

 2,552 total views,  1 views today