How to program your remote

MOVE YOUR CAR OUT OF THE GARAGE AND MAKE SURE THAT NOTHING IS IN THE WAY OF THE DOOR CLOSING

1 Locate where your 3 buttons are check the sunvisor or under your mirror or up above the mirror.

2 Then push 1 of the 3 buttons and see if the little light near the button comes on it could be green yellow or red . If not you will need to put the keys in and turn them

3 Then push 1 and 3 AT THE SAME TIME the little light will come on and stay on KEEP HOLDING INTILL THE LIGHT STARTS TO BLINK it can take up to 1 long minute

4 Then push the REMOTE and 1 of the 3 buttons that you want programed AT THE SAME TIME and the little light will blink slowly KEEP HOLDING intill the little light blinks fast then LET GO! Then push the Button to see if the door opens PEASE push for more then 3 seconds TRY IT TWICE.

IF IT DOES STOP HERE

IF IT DOESN’T WORK KEEP GOING…

5 Now your car is ready YOU need to find the SMART BUTTON on your GARAGE DOOR MOTOR LOOK for the little antenna hanging down or look near the light bulb on the motor. NOT ON THE CEILLING!

6 THEN press the smart button ONCE and LET GO DO NOT HOLD IT the light will come on ( some will blink) you have 30 seconds to RUN TO YOUR CAR and push the button in the car push it for 3 SECONDS and LET GO (1) Now push it AGAIN FOR 3 SECONDS and LET GO ( 2) PUSH IT AGAIN AND LET GO ( 3) and PUSH IT AGAIN and LET GO (4) I KN OW THATS FOUR TIME 4 lone times push it agian see it works.

IF NOT TRY IT AGAIN REMEMBER ONCE YOU PUSH THE SMART BUTTON YOU ONLY HAVE 30 SECONDS TO RUN TO THE CAR AND PUSH THE BUTTON 4 TO 5 TIMES ( 3 SECONDS EACH TIME THATS 12 to 15 SECONDS ALREADY ) SO RUN.